Get my home cleaned
A woven rug on a timber floor beside a fabric armchair, with a cleaner working outside the sliding glass door

How-to guide

How to steam clean a rug

Steam clean a rug at home, step by step, and know which rugs to leave to a professional. What matters most is keeping the rug damp, never soaked, and drying it fast.

Updated 13 November 2026. Health and safety points come from four government sources, listed at the end.

The short answer

Check the care label first: synthetic rugs take steam best, and silk, viscose, jute and antique rugs should not be steamed at home. Test a hidden corner for colour run, vacuum well and pre-treat stains. Steam in small sections with slow, light passes, keeping the rug damp, never soaked. Dry it with fans or open windows, and stay off it until it is dry right through.

What you need

  • Vacuum cleaner
  • Steam cleaner or extractor
  • Stain remover and soft brush
  • Clean cloths or towels
  • Fans or a dehumidifier
Step by step

Steam cleaning a rug, step by step

Do these in order.

  1. Check the label and the fibreFind the care label, or flip the rug and check the label or stitching, then check the fibre against the table below. If you cannot tell what it is made of, treat it as delicate and do not steam it.
  2. Test a hidden corner for colour runDab a little of your cleaning product on a hidden corner with a damp white cloth, or steam a small hidden patch, and wait a few minutes. If dye comes onto the cloth or the colour changes, stop. If nothing changes apart from dirt lifting, carry on.
  3. Move the furniture and vacuum slowlyTake the furniture off the rug and open the windows. Vacuum slowly and thoroughly, going over each area more than once, so no loose dirt is left to turn to mud.
  4. Pre-treat stains and let them sitApply a mild rug stain remover sparingly to each mark and work it in gently with a soft brush. Leave it five to ten minutes, or as long as the label says, then blot. Do not rub, scrub or soak the area. Steam alone rarely shifts a set-in stain.
  5. Fill the machine and choose a gentle settingFill the tank as the machine's instructions say. If you add a cleaning product, use one made for rugs and no more than the recommended amount, as too much leaves residue. Fit a rug or upholstery attachment. Choose a gentler setting if there is one, and try it on the hidden corner first.
  6. Steam in small sections, slowly and lightlyWork in small sections, finishing each before the next. Move slowly and steadily with the direction of the pile, using light pressure, and go over each spot no more than twice. Keep the rug damp, never soaked: if water comes up when you press it, stop and blot with a towel.
  7. Draw out water and dry it fastIf the machine has suction, make extra dry passes to lift more water. Then run fans, open windows or use a dehumidifier, and do not leave it in direct sun for hours, which can fade colours. Keep people and furniture off it until it is dry front and back.
What you need

What you need to steam clean a rug

Have these ready before you start.

Vacuum cleaner

A vacuum to lift loose dirt and debris from the pile before any water or steam goes on the rug.

Steam cleaner or extractor

A vapour steam cleaner, which puts out steam with little water, or a carpet steamer, also called an extractor, which sprays hot water and solution into the pile and sucks it back out.

Stain remover and soft brush

A mild stain remover made for rugs, with no harsh chemicals, and a soft brush to work it in gently. Stiff bristles can be too rough for delicate rugs.

Clean cloths or towels

Clean cloths or microfibre towels to blot up extra water as you go, and to check a finished section is not too wet.

Fans or a dehumidifier

Fans, open windows or a dehumidifier keep air moving while the rug dries. A rug that dries quickly holds its shape better and avoids a musty smell.

Health and safety

Health and safety advice from government pages

Each point as a government body puts it, and what its page covers.

Workplace Health and Safety Queensland

Steam can scald

On its page about burns and scalds in the workplace, Workplace Health and Safety Queensland says scalds are burns from hot liquids such as boiling water or steam, and are generally first or second-degree burns. It says second and third-degree burns should be assessed by a doctor or other qualified health practitioner.

Australian Centre for Disease Control

Mouldy rugs and mixing products

The Australian Centre for Disease Control, writing about mould at home, says to have rugs, carpets and mattresses contaminated by mould professionally cleaned, or replace them. It also says not to mix cleaning products, as they can create toxic fumes.

HealthyWA

After vomit or diarrhoea

HealthyWA, on gastroenteritis, says to clean carpet or soft furnishings contaminated with diarrhoea or vomit immediately, using detergent and hot water, and then steam clean. NSW Health gives the same order for carpets in hospitals and aged care.

Which rugs

Which rugs can be steam cleaned at home

Check your rug against this before you start.

RugSteam it at home?Why
Synthetic: nylon, polyester or polypropyleneUsually yesHolds up to steam and dries fast.
WoolGuides differHeat and moisture can shrink it. See below.
Silk or viscoseNoSteam can permanently damage silk's fibres and colours.
Jute or sisalNoHeat can cause browning, and moisture can cause shrinkage and watermarks.
Cotton, or a cotton backingBest notSoaks up water quickly, and a hired machine can leave water in a cotton foundation.
Persian, hand-knotted or antiqueNoHeat and a lot of water can make wool shrink and dyes run.
Glued or latex backingBest notHigh heat can harm latex backings and make backing glue fail.

Checked on 12 November 2026.

Where guides differ

Where guides disagree on steam cleaning a rug

Guides split on these, and the wrong choice can damage a rug.

Vapour steamer or extractor

One guide says a vapour steamer, which uses little water, is gentler and better for most rugs. Another says an extractor controls moisture better, and that a steamer's high heat can damage some rug materials and adhesives. Two warn that machines made for wall-to-wall carpet can use too much water for a rug.

Steam on wool

Three guides say never steam a wool rug, as heat and moisture can shrink and damage it. Three allow it on some wool rugs: two on a low heat and moisture setting, one on modern wool rugs with a care label. Another suggests a gentler method or a professional, who usually uses a low-moisture method or a controlled wash.

What goes in the tank

One guide fills the tank with water at about 60 degrees Celsius, hot but not boiling. Others warn against hot water or high heat on wool and delicate rugs. Some add detergent as the manual says, while another uses clean water only and avoids strong detergents not approved for rugs.

Hanging or flat to dry

One guide hangs a light rug over a clothesline, railing or chairs so air reaches both sides. Others dry it flat, and one warns that hanging a wet wool rug can stretch and distort it.

Official sources

Checked on 13 November 2026.

  1. Workplace Health and Safety Queensland, Burns and scalds
  2. Australian Centre for Disease Control, Preventing mould exposure
  3. HealthyWA, Gastroenteritis
  4. NSW Health, Viral gastroenteritis - infection control implications for hospitals and aged care facilities

Get a rug cleaning quote